NoahComprende
New member
I just finished building my gremlin and everything went exactly according to the build video, until the end. Once disconnected from the computer it doesn't respond to the transmitter controls. When connected to Betaflight in the "receiver' tab, it responds just like it should. The colored bars move side to side and the monitor picture responds to my transmitter inputs. Again in Betaflight, the motors spin up like they are supposed to in the "motors" tab and I was able to get them spinning the right way in BL HELI. When I disconnect from all of that and try to spin up the motors with the transmitter, nothing happens. Also, when I disconnect from the battery and then reconnect, the receiver keeps going into bind mode but even after I re-bind, the gremlin doesn't respond.
It seems to be some kind of simple transmitter setup issue since the gremlin is set up correctly according to the computer software, but I sure can't figure out what it is. Please help me figure this out as it is getting very frustrating.
Thanks
It seems to be some kind of simple transmitter setup issue since the gremlin is set up correctly according to the computer software, but I sure can't figure out what it is. Please help me figure this out as it is getting very frustrating.
Thanks