Raptortech
Foam Addict
So I have an APM which I've been using with relative success for several months. Then I took it out of one airframe and decided to flash the newest firmware while I was at it. I don't know if it was the flashing that did it, but it's no longer connecting to my computer.
It is recognized as a USB device, and the port will open, but Mission Planner and APM Planner aren't receiving any data.
I can't reflash because neither program will recognize the existing firmware.
The yellow RX and TX LEDs on the board never blink.
Here's a vid of me attempting to connect so you can see what I'm talking about:
I have tried reinstalling drivers. Both APM Planner and Mission Planner. Rebooting. Holding down reset on the board.
SUPER frustrated right now!
It is recognized as a USB device, and the port will open, but Mission Planner and APM Planner aren't receiving any data.
I can't reflash because neither program will recognize the existing firmware.
The yellow RX and TX LEDs on the board never blink.
Here's a vid of me attempting to connect so you can see what I'm talking about:
I have tried reinstalling drivers. Both APM Planner and Mission Planner. Rebooting. Holding down reset on the board.
SUPER frustrated right now!