cleanflight throttle setup orange transmitter

[dmisk82]

Hi all has anyone setup the throttle on the hobbyking orange transmitter through cleanflight i can get it low enough to arm my naze but not as low as 1000 to 2000 motors wont start to spool up untill three or four notches up and im getting greatly reduced power on the high end and a big dead zone from about 60 percent throttle , so to sum up , deadzone on low and high end, hover is at roughly 60% throttle and no difference from 60 percent throttle through to full any ideas ?iv tryed matching numbers from reciever tab with min and max throttle in configuration and changing mid point to half of max
Thanks in advance

Naze 32 rev 6
Little bee esc's
1105 gattling motors

 

[albent_33]

I had the same problem and I am still combating it. Sorry but I can't help you at this point. Maybe try adjusting the travel adjustments on the throttle.

 

[Airkaos]

Adjust the travel on the sticks so it matches 1000 min, and 2000 max, 1500 mid, then calibrate the esc's after the endpoint calibrations. This sounds like you did the calibration before changing endpoints.