wrong throttle control

[a.shvayakou]

Hello,
I am newbie.
After binding, the stick located on the right works as a throttle control, but in fact it should be on the left horizontal stick, I don’t know how to fix it
RadioMaster Zorro 4-in-1 , firmware 2.7.0, the throttle stick is on the left.
RadioMaster R88 Receiver V.2
Setup for binding:
InternalRF
Mode MULTI
Type FrSky X
Subtype D16
Status V1.3.3.7 AETR
Ch Range CH1-16
The binding was successful.
My parameters RADIO SETUP:
Rx cannel ord AETR
Mode 2
I tried to change it, but it didn't help.

Could you recommend something please?
Thanks

 

[joelspangler]

Sounds like one of them is actually TAER instead of AETR. I'd simply move the servo channels around even if the labels are weird afterwards. Just swap aileron and throttle channels.

 

[a.shvayakou]

I found the solution. I inserted connector from my ESC to the CH1 of the R88.
The ESC's have to be connected to the CH3.

 

[joelspangler]

I figured in your first comment that when you said AETR, you knew what that meant. AETR means the channel order is Aileron, Elevator, Throttle, Rudder. With AETR, the ESC would need to be in the throttle position (third channel).