Register | Help | Store Account | FliteTest Dashboard
Page 127 of 127 FirstFirst ... 27 77 117 125 126 127
Results 1,261 to 1,263 of 1263
  1. #1261
    Quote Originally Posted by Michael763 View Post
    I tried to set up my MPCNC with needle cutter to cut MPF which is 2' x 4' or roughly 609mm x 1219mm. I set Repetier to have a print area of X=1219 and Y=609. My needle cut well. However the last 450mm was ruined. The parts where printed on top of each other and measurements where skewed. Should I have updated the Arduino? This is the same board that came with the bundle I received from vicious1.com. If I print/cut anything 762mm x 508mm, it all comes out perfectly. I look through the forum on the vicious1 site and could not find an answer. Can any of you help a brother out? Educate me. Thank you!
    Michael

    Did you use ESTLCAM first to set your tool paths before opening in Repetier? My work area is close to yours and I did not need to change anything in the hardware and I also got it from vicious1.

    Rob

  2. #1262
    Quote Originally Posted by RAGII View Post
    Michael

    Did you use ESTLCAM first to set your tool paths before opening in Repetier? My work area is close to yours and I did not need to change anything in the hardware and I also got it from vicious1.

    Rob
    RAGII,
    Yes I use Estlcam V9 to convert DXF to G-Code. This is really stumping me. In Estlcam the tool paths look correct.

    David & RAGII,
    Thank you for your responses.
    Enjoy a blessed day!

  3. #1263
    Michael,

    After looking through all of my settings I suggest you follow David's advice. Make sure in RH that your x dimensions and y dimensions correspond to your x and y movements.

    Also, I checked my configuration.h file and I have the following settings. I do not remember flashing the firmware before I started to change the limits to 1000 but I might have done that.

    // Travel limits after homing (units are in mm)
    #define X_MAX_POS 1000
    #define X_MIN_POS 0
    #define Y_MAX_POS 1000
    #define Y_MIN_POS 0
    #define Z_MAX_POS 200
    #define Z_MIN_POS 0

Page 127 of 127 FirstFirst ... 27 77 117 125 126 127

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •