Turnigy 9X Transmitter Flaps Switch - Nova OSD Flight Mode
I recently purchased a Turnigy 9X transmitter that I wanted to use with my Nova OSD. This proved to be more difficult than I first thought. The following article and video explains how to configure the Flaps Switch to control Flight Modes. I hope this helps.
Last edited by ilovetoflyfpv; 08-12-2012 at 11:48 AM.
Nice first post.
Is this applicable to the er9x or the erfly9x programming?
These instructions are only applicable to the standard firmware. BMSWEB has done a fantastic video on how to achieve this using the ER9X firmware.
Mixing the Turnigy 9X ER9X for Nova OSD Three Position Switch and Trainer for Display Cycle
Last edited by ilovetoflyfpv; 08-06-2012 at 06:28 AM.
Originally Posted by ilovetoflyfpv
Its good to see you worked this out! Well done on working out how to do this on a Stock 9X!