Ft aura and futaba

[johnreto]

Hey guys, having an issue with my aura. Have everything plugged in where it belongs (according to manual), power up and get the blinking blue light then solid green n red, so rx hooked up. I have authority when moving the sticks. But, the gyro doesnt work/stabilize. Gyro to rx via sbus (sbus2 not supported on aura, correct?) What am i missing? Futaba t6k TX with futaba r3008sb RX.
Thnx for the help n advice. Stay calm n fly on.

Cheers

 

[LitterBug]

What switch do you have mapped for the flight mode? Sounds like maybe you have full manual mode selected.

 

[johnreto]

What switch do you have mapped for the flight mode? Sounds like maybe you have full manual mode selected.

3 point Switch C on aux channel 5. Do i have to program something via computer? Cheers

 

[LitterBug]

Hard to say. Unfortunately I am not familiar with Futaba but have used the Aura with Spektrum and FrSky. If you use the Aura config tool, you can verify that the switch is working correctly on the board.

 

[johnreto]

Hard to say. Unfortunately I am not familiar with Futaba but have used the Aura with Spektrum and FrSky. If you use the Aura config tool, you can verify that the switch is working correctly on the board.

Allrighty, will give that a try. Can i hook it up to the pc when tx and rx are on? Or hook up without?

 

[LitterBug]

Either way should be fine. But if you want to check TX/RX functionality, they will need to be connected and on.