Solved How to dry out electronics?

[Mr_Stripes]

I crashed my whoop in wet grass. It sat for a second and then the vtx shut down and I had no control input. What can I do? It was only there for about a minute.

Thanks for the help,
Mr_Stripes

 

[cgisneccesaray]

Do you have corrision x? If so spray it into the reciver and motor.

 

[Mr_Stripes]

No I dont.

 

[cgisneccesaray]

Im just guessing now put it in a warm place and try to dry it off with a towel is what I would do.

 

[cgisneccesaray]

Internet said vaccuming it sucked some water away to dry it off. This was for cell phones should apply here. Also do not turn it on till completely dry. I would wait a day or so.

 

[Liam B]

I crashed in fresh water back in March. I blew the sand out of the motors and let the quad sit in the sun for a while and it was fine

 

[Ryan O.]

When everything's dried out, I'd twst every part in isolatoon to minimize losses incase it shorts.

 

[Keno]

Us your mother's or wife's hair drier but do not get it to close & water mixes well with alcohol and it wil evaportate with a little heat, sunshine works well.

 

[Mr_Stripes]

Thanks for all the input. I ended up letting it sit for 2 days and then plugging it in with the smoke stopper. It worked until I went and crashed it and the antenna ripped off pulling the tiny signal pad with it.