Part Simple Sea Duck Skid Plates 1

Since I don't have any source of water to takeoff or land nearby, just some quick skid plates I designed for the Sea Duck. Just put the hot glue on the plane (not the prints) and attach them. The front plate curves just fine for me with the heat from the hot glue, but you can use a heat gun or blow dryer to curve it if you want. I print four or five rear skids to attach to the back. I land on mostly asphalt and hard packed dirt and this greatly extends the life of the body. 10" props do not drag at all during takeoff, landings and even touch and go's (unless the wind kicks the plane to a wing tip). Ignore the crooked plate on the picture. Wasn't paying attention when i glued it on.