• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

crazy

  1. Flying Oscar

    Help! I need help setting up my FT Dart!

    Hello, a few months ago I bought the FT Dart as my first flite test plane. I built all the foam and electronics for it, but have not been able to set it up with my transmitter. I have been using a Y cable since I am just starting out, and my transmitter is the TGY 9x (it was cheap and has very...
  2. Lancenlink

    This might be crazy enough to fly!

    Any ideas on this concept? So you know how jets usually have the engine in the back and some canards in the front, well what if you replaced the canards with the engines (I swear I'm not drunk!). Essentially the concept was for a twin edf aircraft to have its motors rotate on an axis for...
  3. Andre

    Been a while - Twin EDF Jet

    So it started out with a set of 64mm (3S) EDF motors and some 40AMP ESCs. It ended with what appears to be a decent setup. Fingers crossed. The initial glide tests showed me I could move the battery closer to the main fuse and shorten the nose section. The 2nd round tests with flight controls...
  4. T

    FT Flying 3d Printer

    I know this probably sounds absolutely ridiculous, but I challenge the FliteTest team to make a plane that can fly long enough to 3d print a part for the aircraft carrying the 3d printer. I figure that if you guys can make a cinder block fly than you can somehow fill a plane with enough...
  5. S

    How about a project for an airborn relay station for FPV... 5.8ghz would be nice...

    I would love to see a project using one aircraft with a RX/TX link to rebroadcast video from another aircraft. I know it is nuts, but then that has never stopped you before? There are times where even my great antennas I buy from RMRC run into the laws of physics and 5.8ghz is not very tree...