dtfb

  1. R

    New FPV Scratch Build!

    Hi everyone! I'm a longtime lurker of the FT forums and for my first post I thought I would share my new scratch build design, a currently unnamed FPV pusher: My goal for this plane was to create as efficient a design as I could make out of DTFB for mid range FPV flying while still retaining...
  2. DankCatnip

    Cutting DTFB with a Dremel?

    Hello! This is my first post on the FT Forums, so excuse me if I may mess up here and there. I was wondering, would anybody happen to have any effective DTFB cutting methods using a Dremel?
  3. F

    DTFB FPV Platform

    Good evening Community. I'm working on a new fpv platform based off of a design I found in an article on FT by dharkless. http://flitetest.com/articles/one-sheet-no-waste-twin-tail-boom-3-build It has a 60in wingspan and is designed to house a 2-axis gimbal up underneath the nose for my...
  4. SeattleNiteFlite

    A Freestyle Simple Trainer from scratch

    I just put this model together. It is partly inspired by the Fieseler Storch and the such in proportion. It is foam board with a swappable power pod, and a tail section from a folded (over weight foam board & wrong prop/motor)FT 3D on this, as it was handy and fit the airframe. I may still trim...
  5. P

    Moving to Fiji

    Hi all, I'm moving to Fiji in a couple of months from the States and I am looking for any info on RC flying in Fiji. Clubs, Local Hobby shops, governmental regulations, HobbyKing Shipping into Fiji. any insight is appreciated cause I love my FT planes. I am aware I will not be able to build...
  6. spencertrejo

    Scratch build: FPV Platform from DTFB Based on the FT-SS

    Based loosely on the simple soarer from flight test. Same wing and tail. Wing was modified for ailerons, removed the dihedral and moved the polyhedral to 4" out. The tail has been mostly untouched, besides a small mod on the rudder (no notch forward on the rudders control surface). Will be doing...