esc

  1. J

    Question on Motor and ESC replacement

    I broke the front right arm on my Eachine Falcon 250 Pro and banged up the motor too, from the sound of it. I have to replace the arm and I am going to replace the motor too. The ESC (all the motors and ESCs are stock) should be just fine and I want to keep it. If I buy a new motor should I...
  2. N

    Racerstar 30a esc freak out with Kiss FC

    I have recently finished a quad build, but once I arm the quad and apply throttle the motors don't spin until i give full throttle and the escs begin to beep. There is no control over the motors and as far as I can tell everything is wired correctly. I have manually calibrated the esc using the...
  3. Konrad

    Castle Creations Exemplary Customer Service (Tech Support!)

    For lack of a better place I'll post this here. BTW I love their ESC governor mode, so this applies to their use in heli's and control line models. I’d like to give a shout-out in praise of Castle Creations for exemplary customer service. Unlike most firms today that think customer...
  4. Vampircorn

    Motor Stutter

    I'm running an emax rs2205 2600kv motor with a 40a ESC on a 3S lipo and 5x4 props, and I'm getting issues with the motor stuttering on low throttle. I tried a 12a and an 18a ESC and had the same issue. Is my battery too low voltage or is my ESC too low amperage for the rs2205?
  5. P

    ESCs burning out Help!!!

    Hey everyone, I am making my first quadcopter and am following FT 210 Quadcopter - BUILD video. I am using LUMENIER 30 AMP BL HELI ESC'S. I was using Betaflight to test out the motors. Just after 20s motors spinning on very low throttle all of the ESCs got really hot. Is this normal since there...
  6. milkydeathgrind

    4 TURNIGY Plush 18 amp Speed Controller and programming card

    I'm selling 4 Turnigy plush 18a ESC's with the Turnigy programming card. These ESC's have been put into one build which was never flown so these are basically like new. The ESC's also have 3.5mm bullet connectors soldered onto the three motor wires. These ESC's are about $15 new but I am...
  7. milkydeathgrind

    4 TURNIGY Plush 18 amp Speed Controller and programming card

    I'm selling 4 Turnigy plush 18a ESC's with the Turnigy programming card. These ESC's have been put into one build which was never flown so these are basically like new. The ESC's also have 3.5mm bullet connectors soldered onto the three motor wires. These ESC's are about $15 new but I am...
  8. C

    HELP!! | My E-Flite ESC Isn't working!

    I went to my local hobby store and came back and my motor at first wasn't running very good. it made a weird pulsing noise. then i tried it and it only rotates at ~600 rpm. (normally 20,000 rpm) I checked my battery and it was reading 11.7 V. So I'm not sure what is wrong with my E-Flite 30...
  9. JimCR120

    HiTec Propel Motors

    I've noticed a new banner ad lately. HiTec Propel motors that have an integrated ESC. I don't go through ESC's and therefore wonder why not get some motors with the ESC built in. Has anyone any experience with these specific motors? Has anyone any experience with other motors with the ESC's...
  10. N

    Brushless Motor not running until full throttle

    Hello, I'm trying to test different propellers. I have built a small wind tunnel. I'm using a RCX 1804 brushless motor with a ZTW Mantis ESC. ESCs can be controlled just like a servo. I have an Arduino and breadboard set up with a potentiometer. When the potentiometer is adjusted, the...
  11. L

    Mini flying wing

    Hi all, I was considering building an ultra micro flying wing and had a few questions. First off, how do you get an ESC that is not built into the receiver and does not cost 60$ like the one from HH. Second question, I saw that all the UMX motor use gearboxes, is this necessary? does it effect...
  12. R

    Testing the new Aikon Electronics 4 in 1 esc! FPV freestyle

    Aikon Electronics send me the new 4 in 1 esc/pdb. It has an 5v and 12v power regulator and is capable of running Dshot600!
  13. L

    Hi! I need some advices for troubleshooting on my quad motors.

    Hi there! I'm building a quad 450 with a gimball for photagraphy. I'm running it on a 3s lipo and 30A esc with a naze32 rev6 fc. But when i start it up and try running the motors to check the direction, i notice that the motors are lacking power, and not starting together. I've also calibrated...
  14. A

    Power Pack C - BLHeli 30a ESC Help

    First time posting to forum and wanted to say thanks to flitetest and community! I recently built a ft simple storch with flitetest's power pack C. It's been a great plane and I enjoyed building it up, I've got about 10 flights on it and today seemingly randomly the esc is acting up. This...
  15. H

    What kind of leads do I need to connect esc to motor

    I found some called banana plug is that what I need
  16. J

    Ahhhh ESC/motors go crazy. What is going on?

    I just got the Eachine Wizard x220. It has the Spracing F3 Flight controller, now. That said. I got everything set up and ready to go. I turn it on and go to hover, then it insta-flips and goes crazy (never left the ground, though). I had to use the failsafe to get it to stop. So, I checked...
  17. M

    ESC/ FC issues

    Hi guys, I've just finished my first build using the ft 210 frame, emax 2204-2300kv motors, emax 12a bheli escs, powerosd, X-racer F303, and turnigy i6 receiver. So when I went to program the escs on beta flight I couldn't get them to do anything, no beeps when I plug the battery in or...
  18. GH0ST_DATA

    Motor not responding...

    Hi guys! :) I'm here because my motor (Flite Test Power Pack A, Emax MT 1806) is not responding, even at full throttle. :confused: I tried to calibrate my ESC multiple times, but it didn't work. My ESC is the Flite Test Power Pack A ESC (BL Heli - 12 amp). I watched "Connecting Electronics"...
  19. C

    BLHeli Flashing

    Hey i currently own a set of these: https://smile.amazon.com/gp/product/B00MFK99X2/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1 and was wondering which revision/version of the latest BLHeli firmware i can flash onto them. As they are a generic ESC, i would like to know what firmware is...
  20. D

    Mini ESC vs Regular ESC

    I'm doing a project with these parts: Lumenier 900 kV Motors : http://www.getfpv.com/fx2216-11-900kv-v2.html Lumenier BLHeli Mini 30A ESC : http://www.getfpv.com/lumenier-30a-blheli-esc-2-4s.html 11" Propellers 4000 mAh Battery 11.1V ...