graupner

  1. L

    Transmiter/Reciever woes

    Greetings All, again, It seems like all I do is ask for help on this thing but I can't seem to find answers anywhere else. First a bit of information. I have a Versacopter V.2 that I have been working on and finally got fully assembled. I am useing a Graupner MZ-12 transmitter with a GR-18...
  2. R

    MZ 12 non copter transmitter

    Hello, Does anyone have a way to get the Graupner MZ12 to work with a quadcopter? The version of the mz12 I have only has settings for airplane and helicopter.
  3. T

    Need help with Graupner Mz-12

    So I set up the versacopter exactly as they did and everything seemed to work. I had some slight problems with some lag but it was only when I'd try to pitch backwards, itd take a few seconds to register on the quad and then do it. Recently I was trying to look at all the settings and reading...
  4. F

    New member

    I finally decided to stick my toes into FPV. Have flown RC for many years and picked it back up last year with a DJI Inpire. What I really look forward to is expanding my skills with the smaller faster more fun FPV setups. I'm starting with two quads; A Graupner Alpha250Q and a Lumenier 250. The...
  5. T

    Graupner MZ-18

    I am having an issue setting up my Graupner MZ-18 for a Versacopter. Does anyone have this radio and have set it up correctly? I am new to this radio and so far the learning curve is getting to me..:black_eyed: HELP
  6. N

    Electrohub Y6 Suggestions Wanted

    Hi all. Longtime Flitetest watcher, First time builder and poster. I've ordered an Electrohub Y6 from the Flitetest store with the Hex D power pack. I also ordered a few 4s batteries to go with it. The info on the store says it can run on 4s with "Smaller Props", but what size should I be...
  7. B

    hello from Vancouver BC Canada - shopping for a transmitter

    hello from Vancouver BC Canada. i'm new to the forum, and also new to the RC world. i'm looking for advice on buying a transmitter/receiver/controller. i just built my Versacopter V2 and i was originally planning to buy the Graupner MZ-12 & GR-18 combo from FT, but it was out of stock at the...
  8. M

    Graupner MZ-12

    I think I reprogrammed my throttle hold S1 switch. How do I reprogram it back to throttle hold? Also, if I wanted to program a switch to control lights on my quad, how would I do that on MZ-12? I have a Turnigy Receiver Controlled Switch already installed. Thank you for your time.
  9. M

    Graupner MZ-12 GR-18 Gimbal Control

    I built a 250 quad and use the Graupner MZ-12 with HoTT GR-18. Can I program the DV Knob/Pot on the MZ-12 to control a camera gimbal (tilt)? I have seen others use a servo tester control but it would be nice to use DV knob on transmitter. If so, where would i plug in on GR-18? Secondly, how...
  10. M

    Versacopter GR18 PID settings. Stability etc

    Trying out the versacopter with the Gruapner GR18. Has anyone tried the Gr18?? My experience is that it has very wild oscillations. Manual say may need to adjust the PID via telemetry. Which is fine. I wonder if anyone else has had this experience and how did they overcome. Or, even some PID...
  11. S

    Graupner MZ-12 transmitter and two recievers

    Hello everyone, I have a graupner mz-12 transmitter and two receivers for sale. All are in perfect working condition, only used a few times. The reason I'm selling is I'm looking at going with a different transmitter system. I'm asking $170 shipped. Paypal is a preferred form of payment. I will...
  12. P

    Graupner GR-24 12ch receiver

    Hi guys, I am running the MZ-24 and GR-24 Hott system in a big scale scratch build balsa P-38. With a multitude of servos, multiple on same channels via Y-leads, and 3 power-hungry electric retracts, am I in danger of overloading the receiver? It seems like a lot of amp draw thru that little...
  13. M

    Graupner MZ12 and Anylink2

    I have the Real Flight 7.5 simulator with the wireless FOB. I also have a Graupner MZ12 and an Anylink2 to try to convert to the SLT that the fob needs. Does anyone know how to setup the Graupner? I have the jack set to DSC and I have a switch to toggle teacher/pupil settings. Is there anything...
  14. T

    Graupner Hott Fan

    Good morning all, I am interested in buying a Graupner Hott Fan and I have a Spektrum D9 radio, does anyone know if they will pair with the Spektrum Transmitter, or what modifications would I need to make to get them paired? Thanks, Tony Gralund San Jose CA
  15. J

    Graupner receiver compatibility

    Hey, I'm new to the FT Speed builds and I was about to order the receiver. My question is I have a spectrum dx5e and wondered is it compatible with the graupner receiver.
  16. F

    Graupner Vs. Spektrum

    I am looking to really upgrade my transmitter and im looking at the Spektrum DX9 Black Edition or the Graupner MZ-24. Im willing to spend the $599 for the Spektrum but im wondering what is the better transmitter. I fly mainly multirotors and will be getting more into planes as well. It seems...