kk2

Hi, I am a 12 year old boy and I am trying to make my first quad copter (SK450). I have already assembled most of the thing. I am using a KK2 flight controller and I am having some trouble figuring out which order to put the ESCs and the receiver on the board. The manual says to put through...

Hey i just finished my first tricopter, mountet the KK2 board connected the ESC in the order that i understod Left ESC = Channel 1 Right ESC = Channel 2 Rear ESC = Channel 3 YAW servo = Channel 4 But i have the following isues / Problems 1. Motor 1(Left) Spins up at low throttle,,, if i giv...

Hy, I'm new here :D I want to build a flight control board something like KK2 board. But not necessarily so complicated. I want to build it from scratch, form parts list, design, circuit diagram in Eagle (or other program) to programing it. I know it's hard work. :)) Any idea where can I...

Ok, summary: - got KK2 board - wanted to flash to 1.6 firmware - got wrong programmer (desired one out of stock). - programmer not recognized by KKMulticopter Flashtool - try alternative programmer (that does not set fuses correctly) - flash succesfully (so the software says) - KK2 blank screen...

I've built a V-Tail quad and I was considering playing around with the mixer editor a little bit. The default V-Tail has 100% of the yaw control coming from the back two motors (similar to a tri), whereas an ordinary quad uses all 4 motors to yaw by changing motor pair speeds. So, I was...

Hey all, At the beginning of the summer, my grandpa approached me and said that he'd like me to hunt down a quadcopter for him that he could fly and use for aerial photography. This would be my first quad and his first RC project. Here is a fraction of my experience with the quad. I chose the...

Got a bat bone and KK2 board. Motors power up just fin. Tail servo does not move connected to output #4 on KK2. Yaw controls shows working in "receiver test" on KK2 board. Connecting servo directly to receiver works fine. Any ideas? Thanks, JD

I've built a 2.5(ish) tricopter with a kk2 board and initially after building it, it was flying well. Lately it has developed a problem where it will go into an oscillation from which it does not recover and then crashes. I had modified the self-level p.gain and p.limit from 65 to 85, but have...

HI All. So I am finally getting around to putting my KK2 onto a DJI frame (DJI equipment all around with an added ESC for powering everything up). With default settings the whole thing vibrated violently. Figured PIDs needed to be turned down. There is still a little bit of vibration but it's a...