versacopter

I bought the Versacopter with the E pack. I assembled according to the instructions on the videos and managed to configure the Naze 32 rev 6 according to the instructions. The problem I have is that the motors don't spin as they should. When I turn on the throttle the motors just vibrate but...

So I am wanting to get a decent FPV setup for my birthday. Never used FPV before, but I'd be using my versacopter as the platform. I've been doing lots of research on different setups, and I really can't figure out what to get. I'm on a budget, but I still want something that's going to preform...

Hi everyone. I've finally gotten around to building my Versacopter and have sourced my Naz32 rev 6 board outside of flitetest. In any case, I have it all soldered up (with a sidepin layout) and it seems the new board doesn't cleanly fit into the versacopter becuase of the 10x1 pin breakout...

I am a newbe when it comes to FPV. I am building the VersaCopter 280 just like Flitetest did a build video on. I am going to use a Mobius w/Transmitter Dock. I would like to wire in a voltage alarm. I am going to use a zippo 2200mAh 4c but Flitetest used a 3c so I might get a few 3c's. I am...

Trying out the versacopter with the Gruapner GR18. Has anyone tried the Gr18?? My experience is that it has very wild oscillations. Manual say may need to adjust the PID via telemetry. Which is fine. I wonder if anyone else has had this experience and how did they overcome. Or, even some PID...

Hi there I just receive my new Versacopter and Naze32 board and have tons of problem with it. Firstly, Cleanflight kept giving the message "GITHUB Query Failed: API rate limit exceeded for 220.255.227.18". Secondly, when I tried to flash the firmware, it gave a message "No response from...

Hi everyone i just bought the new Versacopter, and i have the naze32 inside for the FC, but when i go to fly it it takes off and flips backwards. I have read a ton of forms saying to set up the naze32 into horizon mode instead of acro mode, but i can't find the setting to do that. I have already...

Hi everyone i just bought the new Versacopter, and i have the naze32 inside for the FC, but when i go to fly it it takes off and flips backwards. I have read a ton of forms saying to set up the naze32 into horizon mode instead of acro mode, but i can't find the setting to do that. I have...

Hi there, I am quite new to DIY quadcopter and would like to ask the community for help as I would like to purchase all the parts once as shipping to Singapore is extremely expensive. Here is what I already have: -Futaba 10CHP transmitter -Futaba R2008SB receiver Here what in my Flite Test...

Checkout my Versacopter build! Setup: Platform - Versacopter (obviously ;)) Control board - Naze32 loaded with 4 cell PID settings from Flitetest Motors - Lumenier FX2206-13 2000KV ESC - Lumenier Mini 20A ESC w/ SimonK AutoShot Props - Gemfan 6x4.5 Carbon Nylon Video transmitter - ImmersionRC...

Hello all. I am using a Naze32 Acro board with the DX6, cleanflight and a spektrum 6 channel AR610 receiver for a Flitetest Versacopter. I followed all of the directions on the build videos. I flashed the board with the latest firmware. This procedure worked and when I tilt the board the graphic...

Hi everyone...I bit the bullet and decided to try to build my first multi rotor...a versacopter 280 that just came out. I'm brand new to all of this. I've done everything by watching the videos and putting it all together. I'm to the point to configure Cleanflight on my Naze32 board. I get it...

I built this a few weeks ago. But have just been able to fly it this weekend. I came from a LaTrax Alias, to this. So things are still a little overwhelming to me. PID, curves, AHHH. Still learning. Kinda wobbly but I think some gains need to be turned down. I flew on Angle mode for this because...

I just thought I would share a bitmap I made for the model image of the Versacopter for your Taranis Radio... Enjoy;)

Does anyone have a model of the VersaCopter for Phoenix? I haven't had much luck searching the forums or the Google. Thanks!

Hello everyone. So my roommate and I have been watching flitetest for quite some time now. We have been building many of their planes. I have been looking into a quadcopter for a while and I have been torn on what to get. After seeing the flitetest versacopter recently, my roommate and I decided...

I'm planning on ordering the VersaCopter kit, and am in the process of deciding how to best populate it for my needs. Most of the time it will be used for FPV racing, but occasionally I'd like to configure it for videography with a GoPro. Which motors would you recommend for these applications...