$10 Chuck Glider Converted To EDF RC
- Thread starter mountaindewdude76
- Start date
Hai-Lee
Old and Bold RC PILOT
It will work but if the thrust tends to push the nose down you could use a movable surface in the outlet or just past it, operated by a servo and one of the Aux knobs on your Tx. A sort of thrust angle trimming dynamically albeit manually. A bit like a hovercraft rudder setup but horizontal rather then vertical.
Have fun!
Have fun!
mrjdstewart
Legendary member
since i just maidened my 2 new gliders today, i say yes it will!
make sure you have plenty of motor down thrust or lot's of up trim in elevators for launch. my pusher hit the ground on all 3 launches but then just skidded a long for a bit and sprang into the air. after that the thrust issue didn't seem to be an issue. as for throws, you can't have enough...
good luck,
me
make sure you have plenty of motor down thrust or lot's of up trim in elevators for launch. my pusher hit the ground on all 3 launches but then just skidded a long for a bit and sprang into the air. after that the thrust issue didn't seem to be an issue. as for throws, you can't have enough...
good luck,
me
mountaindewdude76
Junior Member
I forgot about that episode. I just hope the 64mm fan is enough. If not, I'll get a 70mm EDF lol
Similar threads
