Help! 350qx

[Thejim]

I have a 350qx3 that I just changed the main board. I can not get it to bind I looked it up in different places and I am doing it right but can not get it to bind. I also have a 350qx that has been sitting around for years and that one I can not get it to bind also. I have the blue light that is blinking telling me that it is in bind mode. Any help would be appreciated.
Thanks TheJim.

 

[Thejim]

I have a 350qx3 that I just changed the main board. I can not get it to bind I looked it up in different places and I am doing it right but can not get it to bind. I also have a 350qx that has been sitting around for years and that one I can not get it to bind also. I have the blue light that is blinking telling me that it is in bind mode. Any help would be appreciated.
Thanks TheJim.

I read older post and none of it worked. Any other suggestions. Thanks.

 

[AIRFORGE]

I read older post and none of it worked. Any other suggestions. Thanks.

A possible problem could be the transmitter. Do you use the TX for any other models/RX's?
I have a very old 350QX2 with a DX4 TX that wouldn't bind because the batts were low once. Not saying it's the problem but worth trying.

You might want to look through this 350QX3 Playlist, too. Might be helpful.

 

[Thejim]

A possible problem could be the transmitter. Do you use the TX for any other models/RX's?
I have a very old 350QX2 with a DX4 TX that wouldn't bind because the batts were low once. Not saying it's the problem but worth trying.

You might want to look through this 350QX3 Playlist, too. Might be helpful.

Thanks but i don’t think so I tried a new one that i just bought. My qx350 I still can’t to bind but my 350qx3 the one I changed the main board I got it to bind and have a solid green light after 20 seconds or so but I can not get to start up the motors when I move the right stick it just beeps. The manual said to move it to the left then to the right fast. But still the same thing happens. I tried different things with the transmitter because but nothing works. Any tips on what I can try next.
Thanks the Jim.

 

[Bricks]

When binding try moving the transmitter a distance away from the receiver, I will usually turn my back to what I am trying to bind too, could be swamping the receiver...

 

[Thejim]

When binding try moving the transmitter a distance away from the receiver, I will usually turn my back to what I am trying to bind too, could be swamping the receiver...

Thanks tried did not work.

 

[Thejim]

A possible problem could be the transmitter. Do you use the TX for any other models/RX's?
I have a very old 350QX2 with a DX4 TX that wouldn't bind because the batts were low once. Not saying it's the problem but worth trying.

You might want to look through this 350QX3 Playlist, too. Might be helpful.

Tried 2 different ones and a new one I bought none worked. I did get my 350qx to bind and it has the green light but the motors will not go on. When ever you move the right stick the transmitter beeps. Any ideas on that one. Thanks again. This thing is driving me crazy.

 

[Thejim]

When binding try moving the transmitter a distance away from the receiver, I will usually turn my back to what I am trying to bind too, could be swamping the receiver...

Thanks but did not help.