3D Print Tenet; Nose

alan0043

Well-known member
Hi Everyone,

I have a question or too about the 3D print Tenet nose. It looks like the nose is held in place using 2 magnets. The magnets size looks to be 3/8" dia. If I am wrong about the size, please let me know. I have done a search for the magnets but I not find what can work. I can find magnets but no magnets with a steel receiver piece that is the same size as the magnet. Were did you find your magnets ? I have looked at Home Depot and some of the big box stores. Please point me in the right direction.

Thank you for any help,
Al
 

txrocks

New member
What did you use for wings on your 3D printed Tenet ? I am printing the parts now and was going to start building the wings. I have the foam board. I did not buy the wings from FT.