3D Printable Thrust Stand V.1

[Houndpup Rc]

So my 17" propellers pulled 10.5 lbs of thrust, 754 watts, and only 35 amps. So going with some 19" on the see duck. 20's would be to tight of a fit I think.

Nice! (It's amazing how little amps these motors draw!)

 

[RickHunter]

On the plane. 19 only had about 3/4 of an inch clearance, so figured 20 would be too close.

 

[Houndpup Rc]

On the plane. 19 only had about 3/4 of an inch clearance, so figured 20 would be too close.

Ah okay👍 (I was pretty sure I gave enough room on the stand for a 20"+..Just couldn't remember)

 

[RickHunter]

Plenty of room on the stand. Think that motor could handle a 20" though. Especially in the thin air I fly in.

 

[RickHunter]

Eventually I'll do a thrust test on the 19", but I needed to get everthing put together, and give the wife her living room back.