3dLabs P51 question.

[Juliemac]

Printing the mid section between the wings and the tail section, it appears the section is 190mm and the print area is 180mm on the Forge 3D printer.

any one have a work around?

 

[LitterBug]

Rotate it 45 degrees so it is diagonal across the build plate....

Cheers!
LitterBug

 

[Juliemac]

Problem is the height or Z axis. I bought the Forge 3D and was hoping for a "fix" or work around.

 

[LitterBug]

Probably best to run it by 3DLabPrint on their forum. They may have alternate files they can provide to you.

Cheers!
LitterBug

 

[Keno]

What I have done in this type of problem is some of the slicer programs allow you to cut it half or whatever and the print and each half seperatly. Of course then you would have to glue these together without printed tabs or such. Edit: Did not realize how old this post was you probably found a fix for the problem