For sale, four very lightly used SimonK 10A ESCs which are already mounted to a power distribution board.
I had this setup in my Diatone FPV250 for about four flights, so less than a couple hours runtime on them.
The wires have been removed as well as the heat shrink, so you can solder directly to the pads.
It fits perfectly into the Diatone FPV250 frame, but they can of course be removed from the PDB and the power wires lengthened to fit any other similar frames.
The PDB has an XT60 connector for the battery and a JST connector to connect to flight controller voltage input.
$30 shipped and can accept paypal
I had this setup in my Diatone FPV250 for about four flights, so less than a couple hours runtime on them.
The wires have been removed as well as the heat shrink, so you can solder directly to the pads.
It fits perfectly into the Diatone FPV250 frame, but they can of course be removed from the PDB and the power wires lengthened to fit any other similar frames.
The PDB has an XT60 connector for the battery and a JST connector to connect to flight controller voltage input.
$30 shipped and can accept paypal
