Hello,
I have three A2212 13T 1000Kv motor, three 30 amp HW ESC and a 2,200 20C 3s Venom battery pack. The flight controller board is an arduino. For some reason, when I run the motor, it goes all the way up to 50% throttle and cuts off an re-calibrates. I know this is not a problem with the flight controller as the motors runs perfectly without props.
A2212 13T motors draw a maximum of 12 amps(stall current).
Battery can supply 2.2*20=44 amps.
Propellers are 10*4.5 carbon fiber
Any reason for this?
Thanks
I have three A2212 13T 1000Kv motor, three 30 amp HW ESC and a 2,200 20C 3s Venom battery pack. The flight controller board is an arduino. For some reason, when I run the motor, it goes all the way up to 50% throttle and cuts off an re-calibrates. I know this is not a problem with the flight controller as the motors runs perfectly without props.
A2212 13T motors draw a maximum of 12 amps(stall current).
Battery can supply 2.2*20=44 amps.
Propellers are 10*4.5 carbon fiber
Any reason for this?
Thanks
Last edited:
