Michael9865
Elite member
Seeking recommendations. I have updated my Anet A8 with two MosFET to an AM8 and changed to an Arduino Ramps controller. Everything is working except my bed temp, it has not got above 54 degrees since the upgrade to Ramps. I have the original Anet 12V bed with 14 gauge power leads soldered in place and a 4.8mm Mirror on it, it heated and maintained temperature fine before upgrading to an Arduino Ramps controller.
I tried Autotune multiple times "M303_E-1_C8_S60" and got a time out each time. I was hoping to change the PID settings to see if that helps. Currently they are set at the default of bedKp 10.00,_bedKi .023, bedKd 305.4. I have done multiple searches on the web, here, and YouTube to no avail. I don't know if I am using the wrong wording or just not seeing something obvious. Any positive help would be greatly appreciated.
(I did ask for help in a Facebook group, but they couldn’t get past the thickness of the mirror. My thought is it worked before the upgrade so why is it an issue now?)
I tried Autotune multiple times "M303_E-1_C8_S60" and got a time out each time. I was hoping to change the PID settings to see if that helps. Currently they are set at the default of bedKp 10.00,_bedKi .023, bedKd 305.4. I have done multiple searches on the web, here, and YouTube to no avail. I don't know if I am using the wrong wording or just not seeing something obvious. Any positive help would be greatly appreciated.
(I did ask for help in a Facebook group, but they couldn’t get past the thickness of the mirror. My thought is it worked before the upgrade so why is it an issue now?)