TreadHead98
Member
I got a roll of it to print some autogyro blades, anyone have advice for print settings? @telnar1236?
Anyone have experience with LW-PLA-HT?
- Thread starter TreadHead98
- Start date
telnar1236
Master member
Sorry, somehow missed this post till just now. I just use the same settings as normal LW-PLA - 255 C nozzle and a 60 C bed. Typically I use an extrusion ratio of 0.6.
telnar1236
Master member
That said, I'd suggest using a stronger filament for any kind of blade. LW-PLA has a lower strength to weight ratio so I wouldn't trust it to hold up if PLA or ABS is specified and I'd probably personally go with something like nylon. In general, you should also use extreme caution with any kind of 3D printed rotor since if those blades let go, it can be quite bad.
Similar threads
