So today my parts for my first tiny whoop came in, and was super exited to build and fly as soon as possible. I soldered everything up, and everything seemed to work. The board bound with my Tx. However when I went into cleanflight to play around with settings (while waiting for my motors to arrive) it asked me to update the firmware.
This is the first problem. When I try to flash the firmware, it says port could not be opened. The only way to get cleanflight to recognize the board again is to go into settings and tell my computer to forget the board. Then I unplug the board and re-plug it back in, and we are back to square one.
The second problem occurred when my motors arrived. When I plug the motors in, the Beecore flashes like crazy and all the motors twitch. When I plug it into my computer, my computer tells me your usb device has an error, and I cannot connect.
Beecore F3 EVO (DSM2)
Dx6i
Insane motors from tiny whoop
220mAh 1s lipo
If anyone knows anything that could help with either of these problems I would really appreciate it.
Thanks.
This is the first problem. When I try to flash the firmware, it says port could not be opened. The only way to get cleanflight to recognize the board again is to go into settings and tell my computer to forget the board. Then I unplug the board and re-plug it back in, and we are back to square one.
The second problem occurred when my motors arrived. When I plug the motors in, the Beecore flashes like crazy and all the motors twitch. When I plug it into my computer, my computer tells me your usb device has an error, and I cannot connect.
Beecore F3 EVO (DSM2)
Dx6i
Insane motors from tiny whoop
220mAh 1s lipo
If anyone knows anything that could help with either of these problems I would really appreciate it.
Thanks.