martijn10022
New member
Hey folks,
I'm planning on building an RC plane not wider or longer than 1m.
Now I was given the challenge to carry as much payload as possible, I will compete with others in a few months. This brought me here, to gain some knowledge from the experienced builders.
I'll be using a single propeller engine, and the payload will be placed inside the fuselage.
I attached an image with details about the propulsion
Now what is the best wing type for such a plane?
I saw people recommending versa wings for payloads, but with other variables such as power and weight.
I also saw flat-bottom wings on YT but under-cambered were also recommended.
But I know there are many other profiles.
What should I choose?
Any advise is welcome!
I'm planning on building an RC plane not wider or longer than 1m.
Now I was given the challenge to carry as much payload as possible, I will compete with others in a few months. This brought me here, to gain some knowledge from the experienced builders.
I'll be using a single propeller engine, and the payload will be placed inside the fuselage.
I attached an image with details about the propulsion
Now what is the best wing type for such a plane?
I saw people recommending versa wings for payloads, but with other variables such as power and weight.
I also saw flat-bottom wings on YT but under-cambered were also recommended.
But I know there are many other profiles.
What should I choose?
Any advise is welcome!