Lvet
New member
Hello,
I am using a guide to 3D print a Quadcopter. https://blog.prusaprinters.org/how-to-build-a-3d-printed-micro-drone/
Everything is going ok and I've built the frame, connected motor and transmitter to the flight tower. (HGLRC XJB F413 Omnibus F4 Flight Controller)
Nevertheless, even thought I can connect the transmitter to the quad (I can see the switches and the inputs moving in the receiver section of Betaflight), I cannot find a way to arm and have the motors spinning.
I followed the checklist at https://blog.dronetrest.com/quadcopter-not-arming-how-to-solve-in-betaflight/
But cannot find a way to remove the red "ARM (disabled)" box
I am running out of Ideas
I am using a guide to 3D print a Quadcopter. https://blog.prusaprinters.org/how-to-build-a-3d-printed-micro-drone/
Everything is going ok and I've built the frame, connected motor and transmitter to the flight tower. (HGLRC XJB F413 Omnibus F4 Flight Controller)
Nevertheless, even thought I can connect the transmitter to the quad (I can see the switches and the inputs moving in the receiver section of Betaflight), I cannot find a way to arm and have the motors spinning.
I followed the checklist at https://blog.dronetrest.com/quadcopter-not-arming-how-to-solve-in-betaflight/
But cannot find a way to remove the red "ARM (disabled)" box
I am running out of Ideas