carbon fibre adhesive

[novaz]

I don't have the correct oven for bonding carbon fibre but was thinking that maybe an Epoxy or Gorilla type adhesive would work I am making a fire wall for my new motor to go in the carbon cub any recommendations.
Thanks

 

[Fluburtur]

Epoxy should do that job, it is usually what is used to make carbon fiber in the first place. Sand the surface with coarse sandpaper to give it good grip andit should be good.

 

[Wildthing]

When I install my cf rods I will use epoxy but when I use the cf strips I will sand lightly and just use UHU Por or Foam Tac.

 

[novaz]

Thanks guys I found that both Loctite and JB WELD have some good products that are suitable

 

[Bricks]

AS mentioned above sand with coarse like an 80 grit and clean clean clean using either alcohol or lacquer thinner.