Greetings,
I have watched the FT 210 build video a dozen times or so, and think I built my drone correctly. I used a FPV Radiance flight controller - Light up the sky’s and a FrSky D8R-II plus receiver with my FRSky Taranis plus X9D radio. I went through the BetaFlight procedures like in the video, motors ran as expected... then tried to set up radio. Seemed ok, except for the arm switch setup, didn’t have a servos screen. Tried to bind, using lots of versions of modes and number of channels, but finally got one to work, I think. At least it says lost telemetry when I unplug battery and regained telemetry when I plug it back in. Green LED is barely lit, red LED is also on, on the receiver, but that may be normal from what the receiver instructions say. When I plug the usb back in and go to the radio tab, nothing is happening there when I move sticks, try the arm switch etc. I cannot seem to get any response from the drone with the battery plugged in. I am very frustrated after all the time I have spent building this, and the money spent too, and now it doesn’t seem to work. Desperately looking for ideas.
Thanks,
Dfgraper
I have watched the FT 210 build video a dozen times or so, and think I built my drone correctly. I used a FPV Radiance flight controller - Light up the sky’s and a FrSky D8R-II plus receiver with my FRSky Taranis plus X9D radio. I went through the BetaFlight procedures like in the video, motors ran as expected... then tried to set up radio. Seemed ok, except for the arm switch setup, didn’t have a servos screen. Tried to bind, using lots of versions of modes and number of channels, but finally got one to work, I think. At least it says lost telemetry when I unplug battery and regained telemetry when I plug it back in. Green LED is barely lit, red LED is also on, on the receiver, but that may be normal from what the receiver instructions say. When I plug the usb back in and go to the radio tab, nothing is happening there when I move sticks, try the arm switch etc. I cannot seem to get any response from the drone with the battery plugged in. I am very frustrated after all the time I have spent building this, and the money spent too, and now it doesn’t seem to work. Desperately looking for ideas.
Thanks,
Dfgraper