Does anyone have any tips on finding cg on a wing?

black-hart

Junior Member
Ok I'm new to this sport so sorry if this is a dumb question. But can anyone tell me how far back on a wing cg is normally found?
 

earthsciteach

Moderator
Moderator
Are you asking about a flying wing or a wing on any aircraft? Not that there is a tremendous difference, but flying wings can be pretty cg sensitive.
 

Foam Addict

Squirrel member
Oops.
When some one says "wing", I think flying wing.
For most planes, 30-33% of the wing's width back from the leading edge.
I.E. 9" wing=3" back from the leading edge
 

aiidanwings

Senior Member
Simple. Locate the thickest portion of the wing. Start there and adjust as needed, usually forward.

*Only applies to standards wing aircraft.
 

black-hart

Junior Member
ok everyone I just finished drawing my first wing on foam board .if I did it right my cg will be around 8.5 " back from leading edge .Im going for a slow park flyer something to learn on. can anyone clue me in to a good motor esc and pusher prop combo oh can I use a small wooden dowl in place of carbon fiber spar?