Hello everyone, I'm new in drone flight and after playing a little with my father's Bugs 6 I just purchased my first drone the Wizard x220s from Banggood.
The day before yesterday it finally arrived, I set ti up following the guides on Youtube, everything was working fine the motors were spinning but on my first flight with props on all four motors were twitching and it couldn't lift and started smoking. Now both left motors aren't working as you can see in the video. I read online and suspect ECS' are gone but BLHeli shows all four ECS. I don't have yet soldering equipment so I can't swap test motors and ECS. Later in the afternoon i will open it and take some photographs.
What do you suggest to do in the meantime?? Thank you.
The day before yesterday it finally arrived, I set ti up following the guides on Youtube, everything was working fine the motors were spinning but on my first flight with props on all four motors were twitching and it couldn't lift and started smoking. Now both left motors aren't working as you can see in the video. I read online and suspect ECS' are gone but BLHeli shows all four ECS. I don't have yet soldering equipment so I can't swap test motors and ECS. Later in the afternoon i will open it and take some photographs.
What do you suggest to do in the meantime?? Thank you.