Eclipson Model V

[Keno]

Finally done printing. I’m right at the weight Eclipson indicates with a 3s 1300 all the way forward. CG is just slightly behind the marks on the wing. Fingers crossed!

View attachment 178428

Nice print. presently working with Colorfabb LW PLA printing the Labprint Bungee. No problems and love the weight reduction but the Bungee in a 3 channel and is designed as a great gentle glider and not for flying in windy conditions. So far thing look great and can not wait to see it fly. Printing patience is difficult and can wear thin but you must to seek its rewards.

 

[jpot1]

Maiden success. What a nice flying plane. My Turnigy motor must weigh less than the recommended Sunnysky as i was a little behind recommended CG and all it wanted to do was climb. Going to design up a battery tray with a Velcro strap to add some nose weight and see if that helps.

 

[jpot1]

Printing the model A now from Eclipson. Cool design as the wings print in spiral mode and come out super clean. Printing the fuse now. Anyone else done this model? Tips?