muziekklas
Junior Member
Dear Flitetest forum
I am currently building a scratch built quad copter.
I Bought the E310 motor set from DJI (http://store.dji.com/product/e310-4) and saw in the package that there is a small power distribution board.
Now I've read in the manual to solder the Wires direct on the board But was wondering, would it be better (to detach it later on without unsoldering) to add a connector in between or not?
Also are there any experience with this motor set? Something I should know about this motor set?
I thank you guys in advance!
Cheers from Belgium!
I am currently building a scratch built quad copter.
I Bought the E310 motor set from DJI (http://store.dji.com/product/e310-4) and saw in the package that there is a small power distribution board.
Now I've read in the manual to solder the Wires direct on the board But was wondering, would it be better (to detach it later on without unsoldering) to add a connector in between or not?
Also are there any experience with this motor set? Something I should know about this motor set?
I thank you guys in advance!
Cheers from Belgium!
