Dazzy
Active member
After reviewing the EleksMaker setup and review by TechDaily here,
Skip to about 3/4 the way through and this guy cut foamboard clean through by using a 2.5w laser. Cuts look really clean, so Ive read on the FT forum that lasers wont cut white foamboard, therefore what if either:
1. A sheet of darker paper or maybe even newspaper is placed over the foam and stuck in place with sowing/embroidery pins. Would that laser then cut through the paper and foamboard?
2. Using white foamboard, maybe paint it a darker colour like grey, would that work?
The idea here is to eliminate the reflective nature of foamboard.
Skip to about 3/4 the way through and this guy cut foamboard clean through by using a 2.5w laser. Cuts look really clean, so Ive read on the FT forum that lasers wont cut white foamboard, therefore what if either:
1. A sheet of darker paper or maybe even newspaper is placed over the foam and stuck in place with sowing/embroidery pins. Would that laser then cut through the paper and foamboard?
2. Using white foamboard, maybe paint it a darker colour like grey, would that work?
The idea here is to eliminate the reflective nature of foamboard.