EZ Hornet Banking to right

M2000c RC

New member
Hi! Recently I built the EZ Hornet but, when I added the electronics, it began to bank right and crash. The center of gravity was perfect when the motors were not on (I tested this). Has this happened to anyone else?
 

Bricks

Master member
One of two things come to mind well could be a few more balance left to right, aileron's not adjusted correctly, could be a warp developed no matter which it is can be trimmed out of the plane. Or are you talking under power and banking could then be thrust line.
 

AIRFORGE

Make It Fly!
Moderator
The FT EZ Hornet is one of the FT EZ3 Jets SBK's. It has no ailerons, and no transmitter controlled surfaces. It uses the 2ch EZ pack.

@M2000c RC ,
The motors should be on the back of the wing in pusher config, always with the "nipples" of the props facing in the direction of flight.
Be sure the Right and Left motors are on the correct side of the plane.
Be sure the board is mounted with the LED down, and battery plug forward. If the board is mounted wrong, it will not fly correctly.