Chickenlip
New member
Hey everyone, hope your well
So I'm new here and new to this hobby but I hope this is the right place to find a few answers,
I'm having an issue at the moment with an F405-wing - flashed with INAV and trying to get it to talk to a FS-iA6 in ppm mode.
According to the FC's spec sheet i should use R2 for PPM input.
I am powering the receiver with a separate battery, this should not cause issue as far as I am aware.
If I select PPM in INAV, when I open the receiver tab everything is greyed out.
I have tried to select older firmware, but then INAV tells me to update before I can do anything.
Does anyone have any idea how i could fix this?
(in the long run I do plan to use a different receiver, I'm just annoyed I cannot make this work)
So I'm new here and new to this hobby but I hope this is the right place to find a few answers,
I'm having an issue at the moment with an F405-wing - flashed with INAV and trying to get it to talk to a FS-iA6 in ppm mode.
According to the FC's spec sheet i should use R2 for PPM input.
I am powering the receiver with a separate battery, this should not cause issue as far as I am aware.
If I select PPM in INAV, when I open the receiver tab everything is greyed out.
I have tried to select older firmware, but then INAV tells me to update before I can do anything.
Does anyone have any idea how i could fix this?
(in the long run I do plan to use a different receiver, I'm just annoyed I cannot make this work)
Last edited: