smiling albert
Active member
Hi
Have tried reading other threads and YT clips on this but still got problems.
It is probably me as being a dummy I started to try and bind,then read the instructions and realised it had been done at the factory!
Anyway the situation now is when I connect the bec to the bottom port ,channel 1,the led light flashes on and off ..
When I turn the transmitter on it changes to a constant red light.
However when I plug in a servo and twiddle the controls absolutely nothing happens.
Every so often the transmitter chips at me( electronically laughing at me no doubt for being an idiot)
Is it bound or are the servos dodgy.
Have I connected up ok
Have put in some pictures.
Any help much appreciated
Thanks
Have tried reading other threads and YT clips on this but still got problems.
It is probably me as being a dummy I started to try and bind,then read the instructions and realised it had been done at the factory!
Anyway the situation now is when I connect the bec to the bottom port ,channel 1,the led light flashes on and off ..
When I turn the transmitter on it changes to a constant red light.
However when I plug in a servo and twiddle the controls absolutely nothing happens.
Every so often the transmitter chips at me( electronically laughing at me no doubt for being an idiot)
Is it bound or are the servos dodgy.
Have I connected up ok
Have put in some pictures.
Any help much appreciated
Thanks