Colton12300
New member
I have a Foxeer Monster V2 and it works great, but now I would like to set up the voltage meter to display on the OSD. It came with an input labeled "VSEN" and the wire attached was just a bare wire at the end. I read somewhere that if I was using the 12v pad to power my camera (which I am) I would need to solder that VSEN wire to the VCC pad on my PDB. So I did, and nothing happened. Right now it just displays "3S11.6V" where the battery voltage is displayed, but I use a 14.8v 4s, so it's obviously not reading anything from the battery.
Last edited:
