JR Sport SX600 72mhz to 2.4ghz conversion
So i just finished putting the Corona 2.4ghz DIY kit in my JR radio. I used a 9 pin 2-way toggle switch so could completely isolate the 72mhz from the 2.4ghz transmitters and still use one or the other.
Why? I know, it makes no sense.
Excuse the messy use of hot glue, i just find it easier than shrink tubing
And this below, is the best upgrade of all. So much longer battery life.
Here is a video showing the two frequencies in action.
Note:Obviously in real world application one would always turn the TX on before turning on the RX. even then, only have one RX on at a time. HOWEVER for purposes of this demonstration both 2.4ghz and 72mhz receivers were already on.
So i just finished putting the Corona 2.4ghz DIY kit in my JR radio. I used a 9 pin 2-way toggle switch so could completely isolate the 72mhz from the 2.4ghz transmitters and still use one or the other.
Why? I know, it makes no sense.
Excuse the messy use of hot glue, i just find it easier than shrink tubing
And this below, is the best upgrade of all. So much longer battery life.
Here is a video showing the two frequencies in action.
Note:Obviously in real world application one would always turn the TX on before turning on the RX. even then, only have one RX on at a time. HOWEVER for purposes of this demonstration both 2.4ghz and 72mhz receivers were already on.
Last edited: