FT Aura help?

[crashingsucks]

I have 2 orange lights, one of them on the aura and one on the spectrum slrx2 receiver. What I don’t have is working servos or motor. The travel has been set to 125 for the a,r,e. I disconnected the rx and plug it into another ft aura to confirm that the radio and satellite rx works. I have updated to the latest software. Any ideas to what I am missing? Thanks to all

 

[Flying Monkey fab]

If you have gone far enough to upload the latest firmware that means you are at least a bit familiar with the configuration tool. Build a profile and connect the A5 to your computer like you did when you updated the firmware. From there you can see if the A5 is responding at all.

 

[LitterBug]

I have 2 orange lights, one of them on the aura and one on the spectrum slrx2 receiver. What I don’t have is working servos or motor. The travel has been set to 125 for the a,r,e. I disconnected the rx and plug it into another ft aura to confirm that the radio and satellite rx works. I have updated to the latest software. Any ideas to what I am missing? Thanks to all

Pictures of your setup will help. What are you using to power your setup?

 

[crashingsucks]

Well my flaw was after making a the new config i missed uploading the file back to the a5. It works! But now I have to do allot for fine tuning. Thanks to all

 

[LitterBug]

Well my flaw was after making a the new config i missed uploading the file back to the a5. It works! But now I have to do allot for fine tuning. Thanks to all

Been there, done that!