FT Scout XL Elevator Support and Control Horn 2022-03-06

[ColoFlyer]

ColoFlyer submitted a new resource:

FT Scout XL Elevator Support and Control Horn - FT Scout XL Elevator Support and Control Horn

FT Scout XL Elevator Support and Control Horn
This replaces the Popsicle stick on the elevator, plus adds the control horn. It can be printed flat in PLA or PETG with no supports. Be careful not to use to much hot glue with PLA so as not to melt and deform it as you are installing. It can probably also be installed with CA Glue.

Read more about this resource...