There is no definite answer to your question. Most of the RC car motor are in-runner with relatively long can and running at very high KV. The first challenge is to fine a right gear box, 3:1 or even 5:1, in case your plane is swinging a 9“+ prop. The second challenge is where to place that 7oz, 1300+w, in-runner, with gearbox and 100A Esc into a foamboard plane. So, if you are building a 55” in wing span, over 6lb in AUW, big foam planes, then the answer is “possible”. Otherwise, I would say don’t waste your time.