Help with connecting transmitter to receiver

[Jramsey1]

I have a Radiomaster Zorro with the Spektrum AR620 receiver. I bound the receiver but for the life of me cannot figure out how to configure all the control surfaces and throttles. This is my first build with using the Bronco kit with a V tail. Right now my Receiver order (1-4) is T, A, E. My Channel and Mixer order is AETR. I have channel mapping disabled. The only thing responding is the Left Elevator.

 

[Bricks]

Not familiar with the Zorro radio I am sure some one will be along to help you.

 

[alan0043]

Not familiar with the Zorro radio I am sure some one will be along to help you.

I believe the Zorro is Open Tx.

 

[Houndpup Rc]

I have a Radiomaster Zorro with the Spektrum AR620 receiver. I bound the receiver but for the life of me cannot figure out how to configure all the control surfaces and throttles. This is my first build with using the Bronco kit with a V tail. Right now my Receiver order (1-4) is T, A, E. My Channel and Mixer order is AETR. I have channel mapping disabled. The only thing responding is the Left Elevator.

Maybe this will help you :

 

[Bricks]

I believe the Zorro is Open Tx.

See told you did not know much about the Zorro, so same as any OT radio then ?

 

[Jramsey1]

Thanks a ton! I was able to figure it out. I ran the model wizard and had to change around some of the weights for the servos to get them to move properly. Still have no idea what I’m doing but I know all my control surfaces are working as they should.

 

[Houndpup Rc]

Thanks a ton! I was able to figure it out. I ran the model wizard and had to change around some of the weights for the servos to get them to move properly. Still have no idea what I’m doing but I know all my control surfaces are working as they should.

Glad that helped!