Hi Everyone
Im new here but i have been lurking around the forums looking for answers but cannot seem to find any.
I have just finished building a V tail quad just like Davids but i have used a little different specs on motors and ESCs.
i got - KK2 board, Hobbyking 30A ESC 3A Ubec and NTM prop drive 28-26 1100kv/300w short shaft. And im using a HobbyKing 2.4Ghz 4ch Tx RX v2 and im using 8 inch props on all fours.
I really need help with this as i have searched the net and all around, but still having issues on the quad not flying straight or NOT hovering in one place. It tends to drift to the left. I have used the same specs that is on David's V tail quad scratch build. stick scaling, motor mixer, PI editor, whatever needed to be done has been done and tuned to the same specs David uses. And my KK2 is still on the 1.2 version
Please Help!!!
Im new here but i have been lurking around the forums looking for answers but cannot seem to find any.
I have just finished building a V tail quad just like Davids but i have used a little different specs on motors and ESCs.
i got - KK2 board, Hobbyking 30A ESC 3A Ubec and NTM prop drive 28-26 1100kv/300w short shaft. And im using a HobbyKing 2.4Ghz 4ch Tx RX v2 and im using 8 inch props on all fours.
I really need help with this as i have searched the net and all around, but still having issues on the quad not flying straight or NOT hovering in one place. It tends to drift to the left. I have used the same specs that is on David's V tail quad scratch build. stick scaling, motor mixer, PI editor, whatever needed to be done has been done and tuned to the same specs David uses. And my KK2 is still on the 1.2 version
Please Help!!!