Hi guys!
Got the RTF Bixler from HK yesterday. I put it together, turned it on, everything was ok. It was too dark to go out, so I waited a day.
Today I turned it on again, to test if everything was okay before going out. Everything was ok. I went out, plugged in the battery and nothing but a blinking light. I got back, re-bound, but nothing. When I bind it it goes like this:
1: Turn on RX with the binding plug. LED flashing
2: Turn on TX holding the Button, RX LED stops flashing, goes solid.
3: Pull binding plug, turn RX off.
4a: After this if I turn RX back on WITHOUT turning TX on, LED becomes solid, but nothing happens. No beeping, no control.
4b: If I turn TX off, back on while RC is off, then power RX on, the light on the RX is just blinking again, and I get nothing... no beeps, no nothing. Please help
I don't know if it's normal, but the LED on the Transmitter never blinks. It's always solid.
Got the RTF Bixler from HK yesterday. I put it together, turned it on, everything was ok. It was too dark to go out, so I waited a day.
Today I turned it on again, to test if everything was okay before going out. Everything was ok. I went out, plugged in the battery and nothing but a blinking light. I got back, re-bound, but nothing. When I bind it it goes like this:
1: Turn on RX with the binding plug. LED flashing
2: Turn on TX holding the Button, RX LED stops flashing, goes solid.
3: Pull binding plug, turn RX off.
4a: After this if I turn RX back on WITHOUT turning TX on, LED becomes solid, but nothing happens. No beeping, no control.
4b: If I turn TX off, back on while RC is off, then power RX on, the light on the RX is just blinking again, and I get nothing... no beeps, no nothing. Please help
I don't know if it's normal, but the LED on the Transmitter never blinks. It's always solid.