Hello, so I'v built and flown a couple of time my s500 quadcopter. It weighs 1.5 KG and hovers around half throttle. I have had a frequent problem of it just losing power suddenly, which is due to the turnigy banana connectors not being wide enough with the two banana connectors attached to the power distribution board, so they have room to move slightly which sometimes causes the board to reboot, so I have to tape the connections together for safe flight.
However, today, luckily I was only about half a meter off the ground hovering, without my cameras on the quad, it just flipped upside down, as if I had gone full roll left and lost power and landed upside down on the concrete. There were a few scratches but no real damage luckily. But it got me thinking, if that had happened 100m up ...
I didn't press anything on my tx, so im not sure what would have caused this sudden roll and loss of power to happen ..
Any idea's??
Im running the OpenPilot CC3D .. battery wasnt low or anything I have a low voltage buzzer on it ..
Any help appreciated
However, today, luckily I was only about half a meter off the ground hovering, without my cameras on the quad, it just flipped upside down, as if I had gone full roll left and lost power and landed upside down on the concrete. There were a few scratches but no real damage luckily. But it got me thinking, if that had happened 100m up ...
I didn't press anything on my tx, so im not sure what would have caused this sudden roll and loss of power to happen ..
Any idea's??
Im running the OpenPilot CC3D .. battery wasnt low or anything I have a low voltage buzzer on it ..
Any help appreciated