jamesomega
Junior Member
Duckerons? Decelerons? Split Elevons? Not sure what they're called.
This is a 48" EPS hot wire cutout thoroughly taped and sparred. I was able to fit two DOW board/XPS elevons on each wing and used 2 low resolution (200 steps, ugh) turnigy v-tail mixers and two mixes in my Aurora 9 (a DX6 would have no problem) to get it to work. It's currently missing winglets and a motor, but I'll probably throw a 35mm on it even though it's already showing signs of being tail heavy.
Here's a control surface test video:
Here's a link to a picture on rcgroups on how to connect it all up - your mixes may vary:
http://www.rcgroups.com/forums/attachment.php?attachmentid=5256601
This is a 48" EPS hot wire cutout thoroughly taped and sparred. I was able to fit two DOW board/XPS elevons on each wing and used 2 low resolution (200 steps, ugh) turnigy v-tail mixers and two mixes in my Aurora 9 (a DX6 would have no problem) to get it to work. It's currently missing winglets and a motor, but I'll probably throw a 35mm on it even though it's already showing signs of being tail heavy.
Here's a control surface test video:
Here's a link to a picture on rcgroups on how to connect it all up - your mixes may vary:
http://www.rcgroups.com/forums/attachment.php?attachmentid=5256601
