Tonight I received the last of the parts for my micro quadcopter build, and after flashing the KK Control Board, reprogramming my ESCs and connecting up my ESCs and rx, I went through the standard procedure for starting up the quadcopter, shown in the Flite Test video. I powered on my tx and set the throttle to full, then connected power to my quadcopter. Nothing happened and none of the controls have any effect at all, no beeps or anything, the only thing I noticed was the red light on my rx was lit up. I didn't have any idea what the problem could be so I decided to disconnect the control board and see if each ESC on its own would do anything. So for each ESC I tried plugging them into channel 4 on my rx, powering on my transmitter and plugging in my battery. What I got from this was about two seconds of silence followed by constant beeping, and every ESC/motor did this the same. I'm pretty disappointed and I have no idea what could be wrong. These are the ESCs I'm using: http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=21246
I'll be very grateful to anyone who can offer me their assistance, thanks in advance!
I'll be very grateful to anyone who can offer me their assistance, thanks in advance!