This gotta be some super secret sauce you got going on.. 4 videos about it, no specs, and now not a peep about how you resolved the problem... Yer keelin me here.
This gotta be some super secret sauce you got going on.. 4 videos about it, no specs, and now not a peep about how you resolved the problem... Yer keelin me here.
Hey PsyBorg. I was barking up the wrong tree for some of the issues. The FC and ESC is by FETtec and I also had the Impulse regulator board and OSD connected with a wiring harness. Got a hold of FETec support and here's what they had me do:
Route OSD wires above FC, not between FC and ESC (or below ESC)
Remove GND wire between FC and Apex Regulator
Remove Lipo+ between FC and ESC
Add GND wire between FC and ApexOSD
Th support with FETtec is amazing and fast. I just had to post the issue on github and I had a response within an hour I think.