Is there a thinner servo connector?

[mikedkelly]

I am plugging 7 servos into my flight controller and the connectors are slightly thicker than the space between the pins from servo to servo. By the time I get them all plugged in, they are starting to fan out and I am worried that I am going to crack the solder on the board. Is there a better way to plug these in without soldering them directly to the board?

 

[FlamingRCAirplanes]

I am plugging 7 servos into my flight controller and the connectors are slightly thicker than the space between the pins from servo to servo. By the time I get them all plugged in, they are starting to fan out and I am worried that I am going to crack the solder on the board. Is there a better way to plug these in without soldering them directly to the board?

That bending should be fine. I have never heard of anything thinner. The solder is not directly on the board. It actually goes through it and just bends a little. Again, no worries.

 

[Monte.C]

That has always bothered me too, but I never did anything about it and nothing ever broke.